Shell Shaped Valved Dust Mask Easy Wearing Non Woven Fabric Face Mask

Shell Shaped Valved Dust Mask Easy Wearing Non Woven Fabric Face Mask

1 . Descriptions

FFP2V Dust Mask with Steel nose clip,two head straps.In compliance with the norm EN 149:2001+A1:2009 ,PPE III CATEGORY and Shell-shaped.Have 4-plys, PP spunbond outer layer,actived carbon fiber filtration middle layer,PP meltbrown high filteration layer(94%), PP spunbond inner layer.

• High level filter protection effect
• Low breathing resistance
• Soft and comfortable skill touch lining fabric
• Non-irritating, glass fiber free and latex free
• Surface water resistance
• Adjustable nose clip for 360 degree covering nose and mouth
• Wildly filtering bacterial, droplet, spray of cough, dust, chemical particles.
• Economical, fashion and protective

2 . Warning

• The user should be trained in the fitting and should be aware of the instructions for using prior to donning the respirator.
• Use in adequately ventilated areas,which are not deficiency of oxygen.
• Do not use this respirator when oxygen concentration is less than 19.5%.
• Do not use the mask in explosive environment.
• The mask must be fitted correctly to ensure the level of protection expected is achieved.
• The facila hairs or heards and certain facial charactrtistics may reduce the effectiveness of the mask.
• For mask mark marked “NR”,the particle filtering half mask shall not be used for more than one shift.

3 . How to use?

• Cup respirator in one hand with nosepiece at fingertips,allow headbands to hang freely below hand.
• Hold respirator under chin,with nose piece up
• Locate the upper strap across the crown of the head and the lower strap below the ears.
• Strap must not be twisted
• Using both hands,mould nose clip to the shape of the lower part of the nose to ensure a close fit and good seal.Pinching the nose clip using only one hand may result in less effective respirator peformance.
• The seal of the respirator on the face should be fit-checked before entering the workplace.
• If the user feels the bottom strap is too loose and it is not possible to achieve a satisfactory fit of the mask a knot can be tied in the strap.

​

4 . Mask CE Quality Standards

1 . Stardard : EN : 149 : 2001 + A1 : 2009

2 . Test Machine : TSI 8130

3 . Test Flow : 95Liters/Min

4 . Test Medium : NACL & DOP

5 . Discard and replace the mask if:

• The mask is removed whilst in the contaminated area.
• Clogging of the respirator causes breathing difficulties.
• The mask becomes damaged.
• For respirators protecting against vapours,the smell of vapours present becomes derectable.

face mask for dust protection

exhalation valve respirator

Shell Shaped Valved Dust Mask Easy Wearing Non Woven Fabric Face Mask Images